ENOLABEL
To transfer, in a simple way and without to ruin them, the labels of the wine from the bottle to the album.
Six simple steps will allow you to transport the label from the bottle to your Enorandum.

For an optimal result it is very important, first of all, to run water as warm as possible on the bottle for 20/30 seconds, in order to eliminate the various residual deposited on the label, then dry the bottle tapping it with a clean cloth.

Separate the protecting side of the adhesive and place the transparent part on the bottle in correspondence of the label to be removed so that this last one is on the center of the original label.

Pass the back of a tablespoon over the label, pressing several times to make the adhesive part stick well.

After a few minutes, lift the adhesive on one side paying good attention to the first part that is detaching and to slowly pull, carefully lifting the label from the bottle.

With the scissors cut off the excess of the adhesive label, living an edge of approximately 5 millimeters.

Apply the label in the appropriate space on the tasting card.

If the adhesive of the label on the bottle is very strong, pass again the back of the tablespoon pressing. Attend few minutes and to try again.

Box of 10 Enolabels, euro 5,00